Desktop Memory Upgrade

Preparing your computer for your memory upgrade
Before performing your upgrade you ought to be positive all of your connections are unplugged & the power is off on the unit. Start by placing your computer on a hard surface with an anti-static mat in case you have. By the time the computer is secure put on your anti-static arm bracelet & touch the chassis to discharge any static electricity that you may be carrying with you. In case you are uncertain of how to open the computer case or where the memory is located refer to your manufacturers manual for knowledge.

Maintaining Your Computer
While in your computer's case be positive & check any wires for nicks. Receive a can of compressed air & spray the dust out of your computer, make positive fans are clear & tidy for proper ventilation. It is important to keep the inside of your computer tidy for better airflow.

Locate the memory slots
Memory slots are fundamentally identified in your computer. On a desktop look for to long narrow slots beside another, these slots will have clips on either finish. On a Laptop computer you will have a small compartment on the underside with usually clip-in slots for the SO-DIMM modules.

Installation of your memory
Start by locating the clips on either finish of your modules & lower them. Remove the elderly modules by gently pulling up in a vertical position, and then place the elderly modules in an anti-static bag. Carefully pickup your new memory modules by placing your thumb on finish & index finger on the other finish. Locate the notches to make positive they match up together along together with your module holes & insert the new memory. Once you have inserted the new module make positive it is properly seated & fasten the clips.

After Installation
When you have completed the installation make positive all of your wires are connected & reinstall the case cover. Boot up your computer & if successful your computer ought to recognize the new memory. When you have loaded in to Windows check the following.
Start>Control Panel> Technique
You ought to see technique knowledge or the choice to view the ram & processor speed. You may also download CCleaner it displays your technique knowledge on the application window.

Troubleshooting
Boot up your computer, if your computer does not boot properly re-check your memory to make positive it’s seated properly & reboot. If your computer still doesn't boot remove module at a time to check for a defective module. If your computer doesn't boot with stick but boots with the other it could be a defective module. If your computer is not booting with either module check & make positive the memory module is compatible together along together with your motherboard. If all the above doesn't solve your issue re-install the elderly memory they placed in the anti-static bag & boot up to make positive it is not a bad memory slot. If it works with the elderly RAM you ought to think about requesting an RMA from the manufacturer.

Conclusion
Computer memory is a simple upgrade for anyone even in case you are a computer novice.